Honda Fit manuals

Honda Fit: Side Impact Sensor (Second) Replacement

Removal

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

  1. Remove the cargo area side trim.

  1. Disconnect the side impact sensor (second) 2P connector (A) on the floor wire harness.

  2. BAC
  3. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).

Installation

  1. Install the side impact sensor (second) (A) with a new TORX bolt (B), using a TORX T30 bit. Connect the side impact sensor (second) 2P connector (C) on the floor wire harness.

  2. CB11 Nح (1.1 kgfح, 8.1 lbfئt)Replace.A
  3. Do the battery terminal reconnection procedure.

  4. Clear any DTCs with the HDS.

  5. Confirm proper SRS operation: Turn the ignition switch to ON (II) , and check that the SRS indicator comes on for about 6 seconds, and then goes off.

  6. Reinstall all removed parts.

See also:

Reporting Safety Defects
In the U.S. If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration ...

Rerouting
INFO button ► Setup ►Other ►Routing & Guidance Set whether route recalculation occurs automatically or manually during route guidance. Select an option. The following op ...

Dashboard/Steering Hanger Beam Disassembly/Reassembly (Page-1)
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. ...

© 2026 Copyright www.hfitinfo.com