Honda Fit: Restraints

See also:

Cylinder Head Installation
Clean the cylinder head and the engine block surface. Install a new coolant separator (A) in the engine block whenever the engine block is replaced. Install a new ...

Installation (Part -3)
Remove the vinyl tape from the connectors. Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox. ...

Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace ...