Removal
Remove these items:
Mirror holder
Power mirror
Record the power mirror connector terminals location and the wire harness colors.
Disassemble the power mirror connector (A), and remove the terminals (B) from the connector.
Remove the gasket (A) and the cover (B).
Remove the three screws, and separate the mirror housing (C) from the bracket (D).
Remove the four screws, and separate the power mirror actuator (A) from the housing (B).
Installation
Route the wire harness of the new actuator through the hole in the bracket and gasket, then install the parts in the reverse order of removal.
Insert the new actuator terminals into the connector in the original arrangement.
Apply tape in the areas shown (A), to seal the wire harness.
Reassemble in the reverse order of disassembly.
NOTE: Be careful not to break the mirror when reinstalling it to the actuator.
Reinstall the mirror assembly on the door.
Operate the power mirror to ensure smooth operation.
Map Scale Commands
Display north up
Display heading up
Display zoom in
Display zoom out
Display (specify scale):
1/20 mile (80 m) scale
1/8 mile (200 m) scale
1/4 mile (400 m) scale
1/2 mile (800 m) scale
1 mil ...
DOT Tire Quality Grading (U.S. Vehicles)
The tires on your vehicle meet all U.S. Federal Safety Requirements. All
tires are
also graded for treadwear, traction, and temperature performance according
to Department of Transportation (DOT) ...
Ignition Switch
Manual transmission models
WARNING
Removing the key from the ignition switch
while driving locks the steering. This can
cause you to lose control of the vehicle.
Remove the key from the ignit ...