Honda Fit manuals

Honda Fit: Rear Door Rear Sash Trim Replacement

NOTE: Take care not to scratch the door or related parts.

  1. Remove the door quarter inner trim.

  1. Remove the screw securing the trim to the door quarter.

  2. Fastener Location: Screw, 1BCA??B
  3. Pull up the door rear sash trim (A) to release the hooks (B, C), then remove it from the door.

  4. Install the trim in the reverse order of removal.

See also:

A/T Secondary Shaft Sealing Ring Replacement (A/T)
The sealing rings are synthetic resin with chamfered ends. Check the condition of the sealing rings, and replace them only if they are worn, distorted, or damaged. For a better fit, squeeze ...

Driveshaft Disassembly
Special Tools Required Threaded Adapter, 22 x 1.5 mm 07XAC-001010A Slide Hammer 5/8''-18 UNF, commercially available Bearing Puller, commercially available Boot Band Pliers, commerci ...

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

© 2022 Copyright www.hfitinfo.com