SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE: Take care not to scratch the dashboard or its related parts.
While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them inward, then lower the glove box.
Remove the screws, then remove the glove box striker (A).
Install the glove box striker in the reverse order of removal.
Tire and Loading Information Label
The label attached to the driver’s doorjamb provides necessary tire and
loading
information.
The tire and loading information label attached to the
driver’s doorjamb contains:
1 The number ...
Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly.
Disconnect the output shaft (countershaft) speed sensor connector, and
remove the output shaft (countershaft) speed sensor (A).
...
Refilling Window Washer Fluid
Models without washer level sensor
Check the amount of window washer fluid. Look for 1/2 mark on the reservoir.
If the level is low, fill the washer reservoir.
Models with washer level senso
If ...