Honda Fit: Dashboard/Steering Hanger Beam Disassembly/Reassembly (Page-2)
-
From the front of the dashboard (A), remove the screws.
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Special_Symbols";src:url(/statics/ho_prod_2/txt/Honda_Special_Symbols2.txt);}
Fastener Locations: Screw, 10A
-
From the back of the dashboard (A), remove the screws (B, C), then separate the dashboard from the steering hanger beam (D).
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Special_Symbols";src:url(/statics/ho_prod_2/txt/Honda_Special_Symbols2.txt);}
Fastener Locations: Screw, 4(Silver)B: Screw, 2(Black)CABCDBCBB
-
Remove the screws, then remove the dashboard duct (A) from the dashboard (B).
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Special_Symbols";src:url(/statics/ho_prod_2/txt/Honda_Special_Symbols2.txt);}
Fastener Locations: Screw, 12BA
-
If necessary, remove the screws, then remove the front defogger trim (A) from the dashboard (B).
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Special_Symbols";src:url(/statics/ho_prod_2/txt/Honda_Special_Symbols2.txt);}
Fastener Locations: Screw, 5BA
-
Assemble the dashboard and the steering hanger beam in the reverse order of removal. Make sure the dashboard wire harnesses are not pinched.
See also:
Drive Belt Inspection
Inspect the belt for cracks or damage. If the belt is cracked or damaged,
replace it.
Check that the position of the auto-tensioner indicator (A) is within the
standard range ( ...
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Valve Guide Replacement
Special Tools Required
Valve Guide Driver, 5.35 x 9.7 mm 07742-0010100
Valve Guide Reamer, 5.5 mm 07HAH-PJ7A100
Inspect valve stem-to-guide clearance.
As illustrated, us ...
Categories
