Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Take care not to scratch the dashboard or its related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Remove the dashboard center lower cover.
Remove the dashboard center lower trim (A).
Pry between the dashboard (B) and the upper side of the dashboard center lower trim with the appropriate trim tool. Pry out the trim to release the clips and the hooks (C).
Pull out the dashboard center lower trim slightly toward you, and disconnect the accessory power socket connector (D) and the auxiliary jack connector (E) (if equipped).
Install the trim in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips and the hooks into place securely.
Make sure the connectors are plugged in properly.
Changing Your
Destination
There are four methods you can use to
specify a new destination during route
guidance.
►Say “Find Nearest…”
Searches for the nearest place/landmark
on the map screen (e.g., “ ...
Clutch Replacement (M/T)
Special Tools Required
Clutch Alignment Disc 07JAF-PM7011A
Clutch Alignment Shaft 07JAF-PM7012A
Clutch Alignment Shaft 07ZAF-PR8A100
Ring Gear Holder 07LAB-PV00100
Weight, Remover 07741-0010 ...
Introduction
Congratulations! Your selection of a 2008 Honda Fit was a wise investment.
It will give you years of driving pleasure.
One of the best ways to enhance the enjoyment of your new vehicle is to read
...