Rotating the light switch turns the lights on and off, regardless of the position of the ignition switch.
■ High beams
Push the lever forward until you hear a click.
■ Low beams
When in high beams, pull the lever back to return to low beams.
■ Flashing the high beams
Pull the lever back, and release it.
If you remove the key from the ignition switch while the lights are on, a chime sounds when the driver’s door is opened.
Do not leave the lights on when the engine is off because it will cause the battery to discharge.
Rear Seat Leg Guide Replacement
Push the leg guide cover (A) to release the hook (B), then pull out the
cover from the attaching plate (C) and the holder (D) of the leg guide (E).
@font-fa ...
Service Station Procedures
Refueling
1. Park with the driver’s side closest to the service station pump.
2. Outside of the vehicle, open the fuel fill door by pulling its notched edge.
3. Remove the fuel fill cap slowly. ...
Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...