Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
Click here for an interactive version of this procedure (M/T model, A/T model).
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
Take care not to scratch the front seat, the dashboard, or related parts.
When prying with a flat-tipped screwdriver, wrap it with protective tape to prevent damage.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
M/T model: Remove the shift knob (A).
Remove the console lid (A) from the center console (B).
Pry up on the rear hook (C) with a flat-tipped screwdriver wrapped with protective tape.
Carefully pull up the console lid to release the hooks (D).
Remove the center console (A).
Remove the parking brake cover lid (B).
Remove the console box mat (C), then remove the bolt (D), and the clips (E).
Lift the rear of the console up to detach the clip (F), and pull off the front pin (G) from the heater unit.
Install the trim in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips into place securely.
Make sure the wire harnesses are not pinched.
Authorized Manuals
■ Service Express
For electronic copies of service publications, you can purchase a subscription
to
Service Express. Visit www.techinfo.honda.com for pricing and options.
■ For U.S. O ...
VSA Off Switch Test/Replacement
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned
OFF. Check the tire pressure first.
Turn the ignition switch to LOCK (0).
Remove the driver's da ...
USB Adapter Cable
1. Unclip the USB connector and loosen the
adapter cable.
2. Install the iPod® dock connector or the USB
flash drive to the USB connector.
• Do not leave the iPod® or USB flash drive in the
...