Honda Fit: Front Door Glass Outer Weatherstrip Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the door and related parts.
-
Lower the glass fully.
-
Remove the door sash outer trim.
-
While lifting the rear of the door glass outer weatherstrip (A), slide the weatherstrip rearward, then remove the weatherstrip.
-
Install the weatherstrip in the reverse order of removal, and note these items:
-
Push the weatherstrip into place securely.
-
Make sure that there is no clearance between the rear edge of the weatherstrip and the door sash outer trim.
-
See also:
Installation (Part -3)
Remove the vinyl tape from the connectors.
Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox.
...
Steering Wheel Installation
SRS components are located in this area.
Review the SRS component locations, and the
precautions and procedures before doing
repairs or service.
Before installing the steering ...
SRS Component Replacement/Inspection After Deployment
NOTE:
Before doing any SRS repairs,
check for DTCs, for the less obvious deployed
components (seat belt tensioners, front impact sensors, side impact sensors,
etc).
If there is ...
Categories
