Honda Fit: Middle Front Floor Crossmember Replacement

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Secondary HO2S Replacement
Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Disconnect the secondary HO2S connector (A). Raise the vehicle on a lift. ...

Rectifier Test
Check for continuity in each direction, between the B terminal and P terminals, and between the E terminal and P terminals of each diode pair. All diodes should have continuity in only one ...