Honda Fit: Panels

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Flywheel Replacement
Install the ring gear holder. Loosen the flywheel mounting bolts in a crisscross pattern in several steps. Remove the bolts, then remove the flywheel and the ring gear holder. ...

Engine Oil/Air Separator Installation
Remove all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes. Clean and dry the oil/air separator mating surfaces. App ...