Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
With Front Fog Lights
NOTE:
Take care not to scratch the front bumper.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Remove the front bumper.
Remove the clips, and release the hooks (A), then remove the lower front bumper grille (B) from the front bumper (C).
NOTE: To release the clips, pry up on the center pin at the notch (D).
Install the bumper grille in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips and the hooks into place securely.
Instrument Panel Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
NOTE:
Take care not to scratch the dashboard or its ...
Valve Inspection
Remove the valves.
Measure the valve in these areas.
Intake Valve Dimensions
A Standard (New):
27.85пјЌ28.15 mm (1.0965пјЌ1.108 ...
Power Mirror Switch Test/Replacement
Remove the instrument panel.
Disconnect the 13P connector from the power mirror switch (A).
@font-face{font-family:
"Honda_SymbolMarkeng";src: ...