Honda Fit manuals

Honda Fit: Roof Molding Replacement

Special Tools Required

NOTE:

  1. Apply protective tape (A) to the body. Pry up on the roof molding (B) with the appropriate trim tool (C).

  2. ACBDE
  3. Pull up and slide the roof molding to release the front bracket (D) from the pin (E).

  1. Pull up the front portion of the roof molding.

  1. Pull up and release the rear bracket (A) from the pin (B), then remove the roof molding (C).

  2. ??ACB
  1. Install the molding in the reverse order of removal, and note these items:

    • Take care not to damage the windshield molding.

    • Make sure the roof molding is installed securely.

See also:

Fuel and Emissions System Description - Electronic Control System
Electronic Control Systems The functions of the fuel and emission control systems are managed by the engine control module (ECM) on vehicles with manual transmissions or the powertrain cont ...

Horn Test/Replacement
'09-11 models Remove the front grille cover. Disconnect the 1P connector (A) from the horn (B). @font-face{font-family: "Honda_SymbolMark ...

Side Vent
Click here for an interactive version of this procedure (driver's, passenger's). NOTE: Take care not to scratch the dashboard or its related parts. Pull the upper portion (A) of the s ...

© 2026 Copyright www.hfitinfo.com