Honda Fit: Rear Bumper Removal/Installation
NOTE:
-
Put on gloves to protect your hands.
-
Have an assistant help you when removing and installing the rear bumper.
-
Take care not to scratch the rear bumper or the body.
-
Remove the screws (A), the bolts (B, C), and the clips (D, E) securing the rear bumper (F).
NOTE: To release the clips, pry up on the center pin at the notch (G).
-
Push the tab (A) to release the bottom hook (B), then pull on the rear bumper (C) at the wheel arch areas to release it from the hooks (D) on the side spacers (E).
-
With the help of an assistant, hold the wheel arch portions away from the side spacer (A), and pull the rear bumper (B) to release the bumper from the hooks (C) on the body.
-
Install the bumper in the reverse order of removal, and note these items:
-
Make sure the rear bumper securely engages the hooks on the body and on both side spacers.
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips and the hooks into place securely.
-
See also:
System Initialization
The navigation system must be initialized if
power to the navigation system is
interrupted for any reason (e.g., the
battery was disconnected). ...
Valve Body and ATF Strainer Removal (A/T)
Remove the ATF feed pipe (A) from the regulator valve body (B).
Remove the ATF feed pipes (C) (D) from the servo body (E).
Remove the ATF strainer (F) (two bolts).
...
Using HFL
HFL Buttons
( HFL Talk) button: Press
to go directly to give a command or to answer an
incoming call.
(HFL Back) button: Press to
end a call or to cancel a command.
Help Features
• To h ...
Categories
