Honda Fit: Tailgate Lock Cylinder Replacement
For Some Models
NOTE: Put on gloves to protect your hands.
-
Remove the tailgate lower trim panal.
-
Disconnect the tailgate cylinder rod (A).
NOTE: Check for damaged or stress-whitened rod fastener (B).
-
Remove the bolts securing the lock cylinder (A), then remove the lock cylinder by turning it.
-
Install the lock cylinder in the reverse order of removal, and note these items:
-
Make sure the cylinder rod is connected properly.
-
Make sure the tailgate opens properly and locks securely.
-
See also:
A/T Secondary Shaft Sealing Ring Replacement (A/T)
The sealing rings are synthetic resin with chamfered ends. Check the
condition of the sealing rings, and replace them only if they are worn,
distorted, or damaged.
For a better fit, squeeze ...
Mainshaft Bearing and Oil Seal Replacement (M/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 37 x 40 mm 07746-0010200
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Adjustable Bearing Puller, ...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
Categories
