Honda Fit manuals

Honda Fit: Hood Opener Cable Replacement

NOTE:

  1. Remove these items:

    • Front grille cover

    • Front inner fender, left side as needed

    • Driver's dashboard undercover

    • Kick panel, driver's side

  1. Disconnect the hood opener cable (A) from the hood latch (B).

  2. Fastener Locations: Clip, 3D: Clip, 2EBECADEFDD
  3. Remove the hood release handle (C), and disconnect the hood opener cable.

  4. Detach the clips (D) with a clip remover, release the hood opener cable from the clip (E), and remove the grommet (F) from the body, then remove the hood opener cable from the vehicle. Take care not to kink the cable.

  5. Install the cable in the reverse order of removal.

    NOTE: If the clips are damaged or stress-whitened, replace them with new ones.

See also:

Safety Labels
These labels are in the locations shown. They warn you of potential hazards that could cause serious injury or death. Read these labels carefully. If a label comes off or becomes hard to read (exce ...

Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
Remove the transmission fluid pressure switch A (2nd clutch) (A). Make sure there is no water, oil, dust, or foreign particles inside the connector. Install the new tr ...

Driving Guidelines
On Sport model Your vehicle is designed to give you optimum handling and performance on well-maintained roads. As part of this design, your vehicle has a minimum of ground clearance. • Use cauti ...

© 2026 Copyright www.hfitinfo.com