Honda Fit: Cargo Area Light Test/Replacement
-
Open the tailgate.
-
Carefully pry out the cargo area light (A).
Cargo Area Light:
5 W
-
Disconnect the 2P connector (B) from the cargo area light.
-
Check for continuity between terminals No. 1 (+) and No. 2 (-). There should be continuity. If there is no continuity, check the bulb. If the bulb is OK, replace the cargo area light assembly.
-
Install the light in the reverse order of removal.
See also:
Pressure Plate Inspection and Removal
Remove the transmission.
Check the evenness of the height of the diaphragm spring fingers using
the clutch alignment disc (A), clutch alignment shaft (B), remover handle
(C ...
Fog Light Bulbs
When replacing, use the following bulbs.
Fog Light: 55 W (H11)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove the cover.
► Wrap the flat-tip screwdriver with a cl ...
SRS Component Replacement/Inspection After Deployment
NOTE:
Before doing any SRS repairs,
check for DTCs, for the less obvious deployed
components (seat belt tensioners, front impact sensors, side impact sensors,
etc).
If there is ...
Categories
