Honda Fit: Front Individual Map Light Test/Replacement (With Navigation)
With navigation
-
Turn the individual map light switch OFF.
-
Carefully pry the lens (A) off with a small screwdriver.
Individual Map Light:
8 W x 2
-
Remove the two screws, then remove the individual map light (B).
-
Disconnect the connectors (C) from the individual map light.
-
Check for continuity between the terminals.
-
There should be continuity between terminal No. 1 and the ground terminal with the switch in the ON position.
-
There should be no continuity between terminal No. 1 and the ground terminal with the switch in the OFF position.
-
-
If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.
-
Install the light in the reverse order of removal.
See also:
Security System
On Sport model
The security system helps to protect your vehicle and valuables from theft.
The horn sounds and a combination of headlights, position lights, side marker
lights and taillights flash ...
Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
Remove the transmission fluid pressure switch A (2nd clutch) (A).
Make sure there is no water, oil, dust, or foreign particles inside the
connector.
Install the new tr ...
Removal
Raise and support the vehicle.
Remove the rear wheel.
Remove the wire guide grommet (A) from both sides of the axle beam.
@font-face ...
Categories
