Honda Fit: Ignition Switch Replacement
NOTE: SRS components are located in the area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing.
-
Do the battery terminal disconnection procedure.
-
Remove the steering column covers.
-
Disconnect the 7P connector (A) from the ignition switch (B).
-
Remove the two screws and the ignition switch.
-
Install the parts in the reverse order of removal.
-
Do the battery terminal reconnection procedure.
See also:
Removal
Drain the engine coolant.
Remove the air cleaner.
Remove the heater hose clamp bracket mounting bolt (A) and the harness
holder mounting bolt (B).
...
Compact Spare Tire
Use the compact spare tire as a temporary replacement only. Get your regular
tire repaired or replaced, and put it back on your vehicle as soon as you can.
Check the inflation pressure of the compa ...
Front Brake Hose Replacement
Raise and support the vehicle.
Remove the front wheel.
Disconnect the brake line (A) from the brake hose (B), then remove the brake
hose bracket (C).
...
Categories
