Honda Fit: Without navigation
HandsFreeLink Control Unit 28P Connector
|
Cavity |
Wire Color |
Connects to |
|
1 |
BLK |
Body ground to G501 (GND) |
|
2 |
GRN |
HFL switch (STRG SW) |
|
3 |
BRN |
Audio unit (HFL MUTE) |
|
11 |
PNK |
Audio unit (TELEM SIG+) |
|
12 |
GRY* |
Shield for terminals No. 13 and No. 14 (MIC SH) |
|
13 |
LT GRN |
HFL microphone (MIC SIG) |
|
14 |
PUR |
HFL microphone (MIC GND) |
|
15 |
PNK |
No. 1 (10 A) fuse in the under-dash fuse/relay box (+B) |
|
16 |
ORN |
No. 14 (7.5 A) fuse in the under-dash fuse/relay box (ACC) |
|
18 |
LT GRN |
B-CAN bus line |
|
19 |
BLU |
Audio unit (HFL ICON) |
|
25 |
BLU |
Audio-navigation unit (TELEM SIG-) |
|
26 |
GRY* |
Shield for terminals No. 11 and No. 25 (TELEM SIG SIG) |
|
*: |
The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram. |
See also:
Lights
Headlight Aiming
The headlights were properly aimed when your vehicle was new. If you regularly
carry heavy items in the cargo area, readjustment may be required. Adjustments should
be done by yo ...
Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever
(B) with a feeler gauge (C). If the clearance is more than the service
limit, go to step 2.
...
Reverse Shift Fork Clearance Inspection (M/T)
Measure the clearance between the reverse idler gear (A) and the reverse
shift fork (B) with a feeler gauge (C). If the clearance is more than the
service limit, go to step 2.
...
