HandsFreeLink Control Unit 32P Connector
| 
				 Cavity  | 
				
				 Wire Color  | 
				
				 Connects to  | 
			
| 
			 1  | 
			
			 BLK  | 
			
			 Body ground to G501 (GND)  | 
		
| 
			 2  | 
			
			 GRN  | 
			
			 HFL-navigation voice control switch (STRG SW)  | 
		
| 
			 4  | 
			
			 YEL  | 
			
			 Audio-navigation unit (GA-NET BUS+)  | 
		
| 
			 5  | 
			
			 GRN  | 
			
			 Audio-navigation unit (GA-NET BUS-)  | 
		
| 
			 11  | 
			
			 BLK  | 
			
			 Audio-navigation unit (AUDIO R+)  | 
		
| 
			 12  | 
			
			 WHT  | 
			
			 Audio-navigation unit (AUDIO L+)  | 
		
| 
			 13  | 
			
			 PNK  | 
			
			 Audio-navigation unit (TELEM SIG+)  | 
		
| 
			 14  | 
			
			 GRY*  | 
			
			 Shield for terminals No. 15 and No. 16 (MIC SH)  | 
		
| 
			 15  | 
			
			 LT GRN  | 
			
			 HFL-navigation microphone (MIC SIG)  | 
		
| 
			 16  | 
			
			 PUR  | 
			
			 HFL-navigation microphone (MIC GND)  | 
		
| 
			 17  | 
			
			 PNK  | 
			
			 No. 1 (10 A) fuse in the under-dash fuse/relay box (+B)  | 
		
| 
			 18  | 
			
			 ORN  | 
			
			 No. 14 (7.5 A) fuse in the under-dash fuse/relay box (ACC)  | 
		
| 
			 21  | 
			
			 GRY*  | 
			
			 Shield for terminals No. 4 and No. 5 (GA-NET BUS SH)  | 
		
| 
			 26  | 
			
			 GRY*  | 
			
			 Shield for terminals No. 11, No. 12, No. 27, and No. 28 (AUDIO SH)  | 
		
| 
			 27  | 
			
			 RED  | 
			
			 Audio-navigation unit (AUDIO R-)  | 
		
| 
			 28  | 
			
			 GRN  | 
			
			 Audio-navigation unit (AUDIO L-)  | 
		
| 
			 29  | 
			
			 BLU  | 
			
			 Audio-navigation unit (TELEM SIG-)  | 
		
| 
			 30  | 
			
			 GRY*  | 
			
			 Shield for terminals No. 13 and No. 29 (TELEM SIG SIG)  | 
		
| 
			 31  | 
			
			 YEL  | 
			
			 Audio-navigation unit (HFT-NAVI MIC+)  | 
		
| 
			 32  | 
			
			 GRN  | 
			
			 Audio-navigation unit (HFT-NAVI MIC-)  | 
		
| 
			 *:  | 
			
			 The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram.  | 
		
HandsFreeLink Control Unit Connector for Inputs and Outputs
Valve Body and ATF Strainer Removal (A/T)
   
	
	Remove the ATF feed pipe (A) from the regulator valve body (B).
	
	
	Remove the ATF feed pipes (C) (D) from the servo body (E).
	
	
	Remove the ATF strainer (F) (two bolts).
	
 ...
   
Storing Your Home Address
   1 Press the INFO button.
2 Select Setup.
3 Select Personal Information.
4 Select Home Address 1.
5 Select Edit Name.
6 Enter a name and select OK.
7 Select Edit Address.
8  Select  ...
   
How to Refuel
   
1. Stop your vehicle with the service station
pump on the left side of the vehicle in the
rear.
2. Turn off the engine.
3. Press the area indicated by the arrow to
release the fuel fill door. Y ...