Honda Fit: HFL Switch Replacement
SRS components are located in this area. Review the SRS component location, and the precautions and procedures in the SRS section before doing repairs or service.
-
Remove the steering wheel.
-
Remove the audio remote switch.
-
Remove the switch cover (A) from the voice control switch (B).
-
Remove the screws (A), and remove the set plate (B).
-
Remove the screws (C), and remove the voice control switch (D).
-
Install the voice control switch in the reverse order of removal.
See also:
Adjusting the Sound
Press the (sound) button, and
rotate
to adjust the setting.
Each time you press the button, a
sound
mode switches as follows.
When the adjustment level reaches the center, you
will ...
Ball Joint Boot Inspection/Replacement
Special Tools Required
Bearing Driver Attachment, 40 mm 07GAF-SE00200
Check the ball joint boot for weakness, damage, cracks, and grease leaks.
NOTE:
If the ball joint boot is ...
Engine Block Drain Bolt/Sealing Bolt Installation
NOTE:
When installing the drain bolt (A), always use a new washer.
When installing the sealing bolt(s) (B), always use a new bolt(s) and
washer(s) (C).
...
Categories
