Honda Fit: Front Individual Map Light Test/Replacement (With Navigation)
With navigation
-
Turn the individual map light switch OFF.
-
Carefully pry the lens (A) off with a small screwdriver.
Individual Map Light:
8 W x 2
-
Remove the two screws, then remove the individual map light (B).
-
Disconnect the connectors (C) from the individual map light.
-
Check for continuity between the terminals.
-
There should be continuity between terminal No. 1 and the ground terminal with the switch in the ON position.
-
There should be no continuity between terminal No. 1 and the ground terminal with the switch in the OFF position.
-
-
If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.
-
Install the light in the reverse order of removal.
See also:
Auto Door Locking/Unlocking
Your vehicle locks all doors and unlocks the driver’s door automatically when
a
certain condition is met.
You can turn off or change to another auto door
locking/unlocking setting using the mas ...
Rear Door Panel Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
Trim Pad Remover Snap-on A 177A or equivalent, commercially available
*Available through the Honda Tool and Equipment Program; call
888-4 ...
Compatible iPod® and USB Flash Drives
iPod® Model Compatibility
This system may not work with all software versions
of these devices.
USB Flash Drives
• Use a recommended USB flash drive of 256 MB or higher.
• Some digital aud ...
Categories
