Honda Fit: Clutch Pedal Position Switch Replacement (With Cruise Control (M/T))
-
Disconnect the 2P connector (A) from the clutch pedal position switch (B).
-
Loosen the locknut (C), then remove the clutch pedal position switch.
-
Install the clutch pedal position switch, and adjust the pedal height.
See also:
CKP Sensor Replacement
Raise the vehicle on a lift.
NOTE: Make sure the vehicle is level, because engine oil will drip out
when you remove the sensor.
Loosen the bolt (A). Remove the bolt (B) and ...
Refilling Window Washer Fluid
Models without washer level sensor
Check the amount of window washer fluid. Look for 1/2 mark on the reservoir.
If the level is low, fill the washer reservoir.
Models with washer level senso
If ...
Transmission Housing Bearing Installation (A/T)
Special Tools Required
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100
Bearing Driver Attachment, 62 x 68 mm 07746-0010500
Driver Handle ...
Categories
