If your vehicle needs to be towed, call a professional towing service or organization. Never tow your vehicle with just a rope or chain. It is very dangerous.
There are two ways to tow your vehicle:
Flat-bed Equipment -
The operator loads your vehicle on the back of a truck. This is the best way to transport your vehicle.
Wheel-lift Equipment -
The tow truck uses two pivoting arms that go under the tires (front) and lift them off the ground. The other two tires remain on the ground. This is an acceptable way to tow your vehicle.
If, due to damage, your vehicle must be towed with the front wheels on the ground, do this:
Manual transmission: • Release the parking brake. • Shift the transmission to neutral. • Leave the ignition switch in the ACCESSORY (I) position so the steering wheel does not lock.
Automatic transmission: • Release the parking brake. • Start the engine. • Shift to D position and hold for 5 seconds, then to N. Let the engine run for 3minutes, then turn it off. • Turn off the engine. • Leave the ignition switch in the ACCESSORY (I) position so the steering wheel does not lock.
Improper towing preparation will damage the transmission. Follow the above procedure exactly. If you cannot shif t the transmission or start the engine (automatic transmission), your vehicle must be transported with the f ront wheels of f the ground.
With the front wheels on the ground, do not tow the vehicle more than 50 miles (80 km), and keep the speed below 35 mph (55 km/h).
Trying to lif t or tow your vehicle by the bumpers will cause serious damage.
The bumpers are not designed to support the vehicle’s weight.
The steering system can be damaged if the steering wheel is locked. Leave the ignition switch in the ACCESSORY (I) position, and make sure the steering wheel turns f reely bef ore you begin towing.
The side airbags help protect the upper torso of the driver or a front passenger during a moderate-to-severe side impact. Do not attach accessories on or near the side airbags. They can interfe ...
Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2. ...
Display menu (if en route, displays the Route screen) Display navigation (if en route, displays the Route screen) Display map Display map guide (when en route, shows the next guidance point) Di ...