
This indicator should never come on when the engine is running. If it starts flashing or stays on, the oil pressure has dropped very low or lost pressure. Serious engine damage is possible, and you should take immediate action.

Running the engine with low oil pressure can cause serious mechanical damage almost immediately. Turn of f the engine as soon as you can saf ely get the vehicle stopped.
1. Safely pull off the road, and shut off the engine. Turn on the hazard warning lights.
2. Let the vehicle sit for a minute.
Open the hood, and check the oil level. An engine very low on oil can lose pressure during cornering and other driving maneuvers.
3. If necessary, add oil to bring the level back to the full mark on the dipstick.
4. Start the engine, and watch the oil pressure indicator. If it does not go out within 10 seconds, turn off the engine. There is a mechanical problem that needs to be repaired before you can continue drivin.
Wear Indicators
The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower than
elsewhere on the tire. If the tread has worn so
that the indicator is exposed, replace the tire.
Worn out ti ...
Front Individual Map Light Test/Replacement (With Navigation)
With navigation
Turn the individual map light switch OFF.
Carefully pry the lens (A) off with a small screwdriver.
Individual Map Light:
8 ...
Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver Attachment 07947-ZV00100
Remove the oil seal from the torque converter housing.
Install the n ...