Honda Fit manuals

Honda Fit: Engine Coolant

Adding Engine Coolant

If the coolant level in the reserve tank is at or below the MIN line, add coolant


If the coolant level in the reserve tank is at or below the MIN line, add coolant to bring it up to the MAX line.

Inspect the cooling system for leaks.

Always use Honda Long-life Antifreeze/ Coolant Type 2. This coolant is pre-mixed with 50 percent antifreeze and 50 percent water.

Never add straight antifreeze or plain water.

If Honda antifreeze/coolant is not available, you may use another major-brand non-silicate coolant as a temporary replacement. Make sure it is a high-quality coolant recommended for aluminum engines.

Continued use of any non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail. Have the cooling system flushed and refilled with Honda antifreeze/coolant as soon as possible.

If the reserve tank is completely empty, you should also check the coolant level in the radiator.

Removing the radiator cap while the engine is hot can cause the coolant to


Removing the radiator cap while the engine is hot can cause the coolant to spray out, seriously scalding you.

Always let the engine and radiator cool down before removing the radiator cap.

1. Make sure the engine and radiator are cool.


1. Make sure the engine and radiator are cool.

2. Relieve any pressure in the cooling system by turning the radiator cap counterclockwise, without pressing down.

3. Remove the radiator cap by pushing down and turning counterclockwise.

4. The coolant level should be up to the base of the filler neck. Add coolant


4. The coolant level should be up to the base of the filler neck. Add coolant if it is low.

Pour the coolant slowly and carefully so you do not spill any.

Clean up any spill immediately; it could damage components in the engine compartment.

5. Put the radiator cap back on, and tighten it fully.

6. Pour coolant into the reserve tank.

Fill it halfway between the MAX andMIN marks. Put the cap back on the reserve tank.

Do not add any rust inhibitors or other additives to your vehicle’s cooling system. They may not be compatible with the coolant or engine components.

See also:

Dashboard Passenger's Tray Lid Removal/Installation
NOTE: Take care not to scratch the dashboard or its related parts. Open the lid. Remove the screws, then remove the passenger's upper tray lid (A). ...

Throttle Body Removal/Installation
caution Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you d ...

SRS Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, check for DTCs, for the less obvious deployed components (seat belt tensioners, front impact sensors, side impact sensors, etc). If there is ...

© 2024 Copyright www.hfitinfo.com