U.S. models only
Your vehicle is equipped with a tire pressure monitoring system (TPMS) that turns on every time you start the engine and monitors the pressure in your tires while driving.
Each tire has its own pressure sensor (not including the spare tire).
If the air pressure of a tire becomes significantly low, the sensor in that tire immediately sends a signal that causes the low tire pressure indicator to come on.
Low Tire Pressure Indicator
When the low tire pressure indicator is on, one or more of your tires is significantly underinflated. You should stop and check your tires as soon as possible, and inflate them to the proper pressure as indicated on the vehicle’s tire information placard.
If you think you can safely drive a short distance to a service station, proceed slowly, and inflate the tire to the recommended pressure shown on the driver’s doorjamb.
If the tire is flat, or if the tire pressure is too low to continue driving, replace the tire with the compact spare tire.
If you cannot make the low tire pressure indicator go out after inflating the tires to the specified values, have your dealer check the system as soon as possible.
Driving on a significantly underinflated tire causes the tire to overheat and can lead to tire failure.
Under-inflation also reduces fuel efficiency and tire tread life, and may affect the vehicle’s handling and stopping ability.
Because tire pressure varies by temperature and other conditions, the low tire pressure indicator may come on unexpectedly.
For example, if you check and fill your tires in a warm area, then drive in extremely cold weather, the tire pressure will be lower than measured and could be underinflated and cause the low tire pressure indicator to come on. Or, if you check and adjust your tire pressure in cooler conditions, and drive into extremely hot conditions, the tire may become overinflated.However, the low tire pressure indicator will not come on if the tires are overinflated.
Although your tire pressure is monitored, you must manually check the tire pressures monthly.
Each tire, including the spare, should be checked monthly when cold, and set to the recommended inflation pressure as specified on the tire information label and in the owner’s manual.
Tire PressureMonitoring System (TPMS) Indicat
This indicator comes on and stays on if there is a problem with the tire pressure monitoring system.
If this happens, the system will shut off and no longer monitor tire pressures. Have the system checked by your dealer as soon as possible.
When you restart the vehicle with the compact spare tire, the TPMS indicator may also come on and stay on after driving several miles (kilometers).
Changing a Tire with TPMS
If you have a flat tire, the low tire pressure indicator will come on.
Replace the flat tire with the compact spare tire.
Each wheel (except the compact spare tire wheel) is equippedwith a tire pressure sensor mounted inside the tire behind the valve stem. You must use TPMS specific wheels. It is recommended that you always have your tires serviced by your dealer or qualified technician.
After you replace the flat tire with the compact spare tire, the low tire pressure indicator stays on. This is normal; the system is not monitoring the spare tire pressure. Manually check the spare tire pressure to be sure it is correct. After several miles (kilometers) driving with the compact spare tire, the TPMS indicator comes on and the low tire pressure indicator goes off.
The low tire pressure indicator or the TPMS indicator will go off, after several miles (kilometers) driving, when you replace the spare tire with the specified regular tire equipped with the tire pressure monitor sensor.
Never use a puncture-repairing agent in a flat tire. If used, you will have to replace the tire pressure sensor.
Have the flat tire repaired by your dealer as soon as possible.
As required by the FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada Standard RSS-210.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference that may cause undesired operation of the device.
Raise and support the vehicle. Remove the front wheels. Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not include the thickness of the back ...
INFO button ► Setup ►Other ►Vehicle Set the off-road tracking feature and correct the vehicle position displayed on the map. Select an item. The following items are availa ...
Fuel Line/Quick-Connect Fitting Precautions
The fuel line/quick-connect fittings (A, B, C, D, E, F, G, H, I, J, K and L) connect the fuel rail (M) to fuel feed hose (N), the fuel feed hose to the fuel line (O), the fuel feed line (P) to the ...