Honda Fit: Map Menu

See also:

Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace ...

Removal
Raise and support the vehicle. Remove the rear wheel. Remove the wire guide grommet (A) from both sides of the axle beam. @font-face ...

Driver's Seat Position Sensor Replacement
Removal NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor. Do the battery terminal disconnection ...