Honda Fit: Interface Settings

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Wiper Arm Replacement
NOTE: Set the wiper arms to the auto-stop position before removal and installation. Windshield NOTE: Always pull up the driver's side wiper blade first. Remove the caps, the nuts, and t ...

Transmission Range Switch Replacement (A/T)
Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported. Shift to N. ...