Why does the vehicle position icon on the map “lag” a short distance behind my actual position, especially at intersections?
This is normal. The navigation system is unaware of the width of intersections. Large differences in vehicle position can indicate a temporary loss of the GPS signal.
Why does the “time to destination” display sometimes increase even though I am getting closer to my destination?
The “time to destination” is based on the posted road speed signs and your actual road speed to give you a better estimate of arrival time.
Why does my clock frequently change the time forward and backward by one hour?
The clock setting is automatically updated based on your GPS location. If you normally drive between two time zones, the clock may keep adjusting the time. You can turn this feature off.
How do I specify a destination when an entered city or street could not be found?
Try entering the street first. Some cities are lumped in with a major metro area. In rural “unverified” areas or new subdivisions, streets may be missing or only partially numbered.
How do I turn on the navigation system voice guidance?
1. Press the INFO button. Select Setup. Check that Volume is not set to Off.
2. Select Other, then Basic Settings. Set Voice Recognition Tutor to On if you want the system to provide confirmations and system prompts.
My battery was disconnected or went dead, and the navigation system is asking for a code. Where do I find it?
Your vehicle comes with a label in the Owner’s Manual kit that includes the system’s security code and serial number.
You should keep this label in a safe place outside your vehicle. If you cannot find it, contact your dealer.
ATF Replacement (A/T)
NOTE: Keep all foreign particles out of the transmission.
Warm up the engine to normal operating temperature (the radiator fan
comes on), and turn the engine off.
Raise the vehic ...
ATF Cooler Cleaning (A/T)
Special Tools Required
ATF Cooler Cleaner GHTTTCF6H
Magnetic Nonbypass Spin-On Filter GTHGNBP2
*: Available through the Honda Tool and Equipment Program 888-424-6857.
Before installing an ...
Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe
flange (C) from the end cover (D).
Install a new O-ring (E) over the 3rd clutch feed pipe.
In ...