Honda Fit: Going Home
1 Press the DEST button.
2 Select Go Home 1.
Alternatively, you can say 
“Go
Home” from any screen. Your home
address is displayed on the Calculate
Route screen.
3 Select Set as Dest.
►The following voice commands are
available: say “Go Home,”
“Go
Home 1,” “Go Home 2.”
►If you have two home addresses stored,
saying “Go Home” will select Home
Address 1.
See also:
MTF Inspection and Replacement (M/T)
Park the vehicle on level ground, and turn the engine off.
Raise the vehicle on a lift, and make sure it is securely supported.
Remove the splash shield.
...
Pilot Bearing Replacement
Remove the crankshaft pilot bearing (A) using the remover weight (B), and
the 15 mm bearing remover shaft set (C).
Install a new pilot bearing (A) into the crankshaft using th ...
Reverse Shift Fork Clearance Inspection (M/T)
Measure the clearance between the reverse idler gear (A) and the reverse
shift fork (B) with a feeler gauge (C). If the clearance is more than the
service limit, go to step 2.
...
Categories
