Honda Fit manuals

Honda Fit: Reporting Safety Defects

In the U.S.

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co., Inc.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in individual problems between you, your dealer, or American Honda Motor Co., Inc.

To contact NHTSA:
Call the Vehicle Safety Hotline toll-free at 1-888-327-4236 (TTY: 1-800-424-9153)
Go to http://www.safercar.gov Write to: Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC 20590.

You can also obtain other information about motor vehicle safety from http://www.safercar.gov.

In Canada

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform Honda Canada Inc. and you may also inform Transport Canada.

If Transport Canada receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may lead to a recall and remedy campaign. However, Transport Canada cannot become involved in individual problems between you, your dealer, or Honda Canada Inc.

To contact Transport Canada’s Defect Investigations and Recalls Division, you may call 1-800-333-0510.

For more information on reporting safety defects or about motor vehicle safety, go to http://www.tc.gc.ca/roadsafety.

See also:

Engine Block Drain Bolt/Sealing Bolt Installation
NOTE: When installing the drain bolt (A), always use a new washer. When installing the sealing bolt(s) (B), always use a new bolt(s) and washer(s) (C). ...

Automatic Transmission
■Creeping The engine may run at a higher idle speed and creeping increases: • Immediately after the engine starts. • When the heating and cooling system is in use. Keep the brake pedal f ...

Clutch Clearance Inspection (A/T)
Special Tools Required Clutch Compressor Attachment 07ZAE-PRP0100 Inspect the clutch piston, the discs, the plates, and the end-plate for wear and damage, and inspect the clutch wav ...

© 2022 Copyright www.hfitinfo.com