This chapter includes your vehicle’s specifications, locations of identification numbers, and other information required by regulation.
Pilot Bearing Replacement
Remove the crankshaft pilot bearing (A) using the remover weight (B), and
the 15 mm bearing remover shaft set (C).
Install a new pilot bearing (A) into the crankshaft using th ...
Main Valve Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
Do not use a magnet to remove the check balls, it may magnetize the check
balls. ...
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...