Honda Fit manuals

Honda Fit: If the EPS System Indicator Comes On

■ Reasons for the indicator to come on


■ Reasons for the indicator to come on

• Comes on when there is a problem with EPS system.

• If you depress the accelerator pedal repeatedly to increase the engine speed while the engine is idling, the indicator comes on, and sometimes the steering wheel becomes harder to operate.

■ What to do when the indicator comes on

Stop the vehicle in a safe place and restart the engine.

If the indicator comes on and stays on, immediately have your vehicle inspected by a dealer.

NOTICE

If you repeatedly turn the steering wheel at an extremely low speed, or hold the steering wheel on the full left or right position for a while, the system heats up. The system goes into a protective mode, and limits its performance. The steering wheel becomes harder and harder to operate. Once the system cools down, EPS system is restored. Repeated operation under these conditions can eventually damage the system.

See also:

Clutch Pedal, Clutch Pedal Position Switch, and Clutch Interlock Switch Adjustment (M/T)
NOTE: For a cruise control problem, check the clutch pedal position switch. For a clutch interlock operation problem, check the clutch interlock switch. Remove the driver' ...

Transmission Housing Bearing Installation (A/T)
Special Tools Required Bearing Driver Attachment, 72 x 75 mm 07746-0010600 Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100 Bearing Driver Attachment, 62 x 68 mm 07746-0010500 Driver Handle ...

Clutch Interlock Switch Replacement (M/T)
M/T model Disconnect the 2P connector (A) from the clutch interlock switch. Loosen the locknut (B), then remove the clutch interlock switch (C). Install the clutch int ...

© 2026 Copyright www.hfitinfo.com