Honda Fit manuals

Honda Fit: Replacing Light Bulbs

See also:

Emissions Testing
Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘‘r ...

Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), the release bearing (C), and the release bearing guide (D) in the shaded areas, then set th ...

Secondary HO2S Replacement
Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Disconnect the secondary HO2S connector (A). Raise the vehicle on a lift. ...

© 2026 Copyright www.hfitinfo.com