Honda Fit: Brake/Clutch Fluid
Specified fluid: Honda Heavy Duty Brake Fluid DOT 3
Use the same fluid for both the brakes and clutch.
NOTICE
Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system and can cause extensive damage.
If the specified brake fluid is not available, you should use only DOT 3 or DOT 4 fluid from a sealed container as a temporary replacement.
Using any non-Honda brake fluid can cause corrosion and decrease the longevity of the system. Have the brake system flushed and refilled with Honda Heavy Duty Brake Fluid DOT 3 as soon as possible.
If the brake fluid level is at or below the MIN mark, have a dealer inspect for leaks or worn brake pads as soon as possible.
Checking the Brake Fluid
The fluid level should be between the MIN and MAX marks on the side of the reservoir.
Checking the Clutch Fluid
Manual transmission mo
The fluid level should be between the MIN and MAX marks on the side of the reservoir.
If the clutch fluid level is at or below the MIN mark, have a dealer inspect for leaks or an excessively worn clutch plate as soon as possible.
See also:
Driver's Airbag Replacement
NOTE:
If replacing the driver's airbag after deployment, refer to
Component Replacement/Inspection After Deployment for a
complete list of other parts that must also be replaced.
...
Start-up
The navigation system starts automatically when you turn the ignition to
ACCESSORY (I) or ON (II). At start-up, the following Confirmation screen is
displayed.
1. Select Change Language.
► ...
Warm Up TWC Removal/Installation
NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC
for debris.
Raise the vehicle on a lift.
Remove the bolts (A).
Lower the vehicle.
...
Categories
