This chapter discusses basic maintenance.
Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever
(B) with a feeler gauge (C). If the clearance is more than the service
limit, go to step 2.
...
Block and Piston Inspection
Remove the crankshaft and the pistons.
Check the piston for distortion or cracks.
Measure the piston skirt diameter (A) at a point 16 mm (0.63 in)
from ...
VIN, Engine, (Motor), Transmission Numbers, and Paint Codes
Vehicle Identification Number
a.
Manufacturer, Make, and Type of Vehicle
JHM:
Honda Motor Co., Ltd.
Honda passe ...