Honda Fit manuals

Honda Fit: Accessories

When installing accessories, check the following: • Do not install accessories on the windshield. They can obstruct your view and delay your reaction to driving conditions.

• Do not install accessories on the side pillars or across the side windows.

Accessories installed in these areas may interfere with proper operation of the side curtain airbags.

• Be sure electronic accessories do not overload electrical circuits or interfere with proper operation of your vehicle.

• Before installing any electronic accessory, have the installer contact a dealer for assistance. If possible, have a dealer inspect the final installation.

See also:

Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe flange (C) from the end cover (D). Install a new O-ring (E) over the 3rd clutch feed pipe. In ...

Voice Control Switch Replacement (With Navigation)
SRS components are located in this area. Review the SRS component location, and the precautions and procedures   in the SRS section before doing repairs or service. Remove the ...

Reassembly
Apply Molykote 44MA grease to the sliding surface of the pivot pin (A) and the parking brake lever (B) for the rearward brake shoe (C). @font-face{font-fami ...

© 2026 Copyright www.hfitinfo.com