Honda Fit: Braking

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Ignition Switch
The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, push it in slightly ...

Clutch Wave-Plate Phase Difference Inspection (A/T)
Place the clutch wave-plate (A) on a surface plate, and set a dial indicator (B) on the wave-plate. Find the bottom (C) of a phase difference of the wave-plate, zero the di ...