■Shift Lever Operation+
Fully depress the clutch pedal to operate the shift lever and change gears, then slowly release the pedal.
Depress the clutch pedal, and pause for a few seconds before shifting into
, or
shift into one of the forward gears for a moment. This stops the gears so they
do not
“grind.”
NOTICE
Do not shift to before the
vehicle comes to a
complete stop.
Shifting to before stopping can
damage the
transmission.
NOTICE
Before downshifting, make sure the engine will not go into the tachometer’s red zone. Should this occur, it can severely damage your engine.
When you are not shifting, do not rest your foot on the clutch pedal. This can cause your clutch to wear out faster.
Recommended Shift Points Driving in the highest gear that allows the engine to run and accelerate smoothly helps to optimize fuel economy and effective emissions control. The following shift points are recommended:
If you exceed the maximum speed for the gear you are in, the engine speed will enter into the tachometer’s red zone. When this happens, you may experience a slight jolt.
Features
Audio System
For navigation system operation
See Navigation System Manual
...
EPS Motor Removal and Installation
NOTE: Do not allow dust, dirt, or other foreign materials to enter the
steering gearbox.
Removal
Remove the steering gearbox.
Remove the EPS motor 3P connector (A) and the EPS ...
Engine Oil Replacement
Allow the engine to reach operating temperature (fan comes on at least
twice).
Remove the drain bolt (A), and drain the engine oil.
Reinstall the drain bolt with a ...