■Creeping
The engine may run at a higher idle speed and creeping increases: • Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal firmly depressed when stopped.
■Kickdown
Quickly depressing the accelerator pedal while driving uphill may cause the transmission to drop to a lower gear, unexpectedly increasing vehicle speed. Depress the accelerator pedal carefully, especially on slippery roads and curves.
Transmission Side - Release Bearing Removal
Remove the transmission.
Remove the release fork boot (A) from the clutch housing (B).
Squeeze the release fork set spring (C) with pliers to remove the release
...
Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the
release fork bolt (B), the release bearing (C), and the release bearing
guide (D) in the shaded areas, then set th ...
Front Turn Signal Light Bulbs
When replacing, use the following bulbs.
Front Turn Signal Light: 21 W (Amber)
1. Turn the socket to the left and remove it.
2. Push in the old bulb, rotate to the left until
it unlocks, and rem ...