Set the park lever in the P position.
Measure the center-to-center distance (A) between the park pawl shaft (B) and the park lever roller pin (C).
Standard: |
37.8пјЌ38.8 mm (1.49пјЌ1.53 in) |
If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.
PARK LEVER STOP
Mark |
B |
C |
1 |
11.00 mm |
11.00 mm |
2 |
10.80 mm |
10.65 mm |
3 |
10.60 mm |
10.30 mm |
After replacing the park lever stop, make sure the distance is within tolerance.
Light Switches
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
■ High beams
Push the lever forward until you hear a click.
■ Low beams ...
Tailgate Handle Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the tailgate or the related parts.
Remove these items:
Tailgate lower trim panel
...
Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver Attachment 07947-ZV00100
Remove the oil seal from the torque converter housing.
Install the n ...