Honda Fit: Synchro Sleeve and Hub Inspection and Reassembly (M/T)
-
Inspect gear teeth on all synchro hubs and the synchro sleeves for rounded off corners, which indicate wear.
-
Install each synchro hub (A) in its mating synchro sleeve (B), and check for free movement. Make sure to match the three sets of longer teeth (C) (120 degrees apart) on the synchro sleeve with the three sets of deeper grooves (D) in the synchro hub.
NOTE: Do not install the synchro sleeve with its longer teeth in the synchro hub slots (E) because it will damage the spring ring. If required, always replace the synchro sleeve and the synchro hub as a set.
See also:
Carrying Cargo
Your vehicle has several convenient storage areas:
• Glove box
• Front door pockets
• Seat-back pocket
• Center pocket
• Cargo area side pocket
• Cargo area, including the rear sea ...
Manual Transmission
Release the parking brake.
Shift the transmission to neutral.
Leave the ignition switch in ACCESSORY (I) so the steering wheel does not
lock.
Make sure all accessories ar ...
Checking the Battery
Check the battery condition monthly. Look at
the test indicator window and check the
terminals for corrosion.
If your vehicle’s battery is disconnected or goes dead:
• The audio system* is d ...
Categories
