Inspect the synchro rings for scoring, cracks, and damage (A).
Inspect the inside of each synchro ring (B) for wear. Inspect the teeth (C) on each synchro ring for wear (rounded off).
Inspect the teeth (A) on each synchro sleeve and the matching teeth on each gear for wear (rounded off).
Inspect the synchro teeth on gear for scoring, cracks, and damage (A).
Inspect the thrust surface (B) on each gear hub for wear.
Inspect the cone surface (C) on each gear hub for wear and roughness.
Inspect the teeth on all gears (D) for uneven wear, scoring, and cracks.
Coat the cone surface of each gear with MTF, and place its synchro ring on it. Rotate the synchro ring, making sure that it does not slip.
Measure the clearance between each gear (A) and its synchro ring (B) all around the gear. Hold the synchro ring against the gear evenly while measuring the clearance. If the clearance is less than the service limit, replace the synchro ring and gear.
Synchro Ring-to-Gear Clearance
Standard: |
0.85пјЌ1.10 mm (0.034пјЌ0.043 in) |
Service Limit: |
0.4 mm (0.016 in) |
Double Cone Synchro-to-Gear Clearance |
|
Standard: |
|
: |
Outer Synchro Ring (B) to Synchro Cone (C) 0.5пјЌ1.0 mm (0.020пјЌ0.039 in) |
: |
Synchro Cone (C) to Gear (A) 0.5пјЌ1.0 mm (0.020пјЌ0.039 in) |
: |
Outer Synchro Ring (B) to Gear (A) |
0.95пјЌ1.68 mm (0.038пјЌ0.066 in) |
|
Service Limit: |
|
: |
0.3 mm (0.012 in) |
: |
0.3 mm (0.012 in) |
: |
0.6 mm (0.024 in) |
Synchro ring-to-gear
Double cone synchro-to-gear
Driver and Passenger Safety
This section gives you important information about how to protect yourself and
your passengers. It shows you how to use seat belts. It explains how your airbags
work. And it tells you how to prope ...
Transmission End Cover Removal (A/T)
Special Tools Required
Mainshaft Holder 07GAB-PF50101
Remove the bolts securing the ATF inlet line (D) and ATF filter holder
(E), the line bolt and sealing washers, and remove the ATF in ...
USB Commands
USB play
USB play track # (#: 1 to 30)
USB skip forward
USB skip back
USB track random*
USB track repeat*
USB track scan*
USB folder up
USB folder down
USB folder random*
USB folder repeat*
...