Measure the clearance between the reverse idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2.
Standard: |
1.30пјЌ1.90 (0.051пјЌ0.074 in) |
Service Limit: |
2.5 mm (0.098 in) |
Measure the width of the reverse shift fork.
If the width is not within the standard, replace the reverse shift fork.
If the width is within the standard, replace the reverse idle gear.
Standard: |
13.5пјЌ13.8 mm (0.531пјЌ0.543 in) |
M/T Differential Carrier/Final Driven Gear Replacement (M/T)
Loosen the bolts in a crisscross pattern in several steps, then remove
the final driven gear (A) from the differential carrier (B).
Install the final driven gear with the cham ...
Place Name
DEST button
► Place Name
Enter the name of a place (e.g., business, hotel, restaurant) stored in the
map
database to use as the destination.
1. Enter a place name.
2. Select List to di ...
Driver's Airbag Replacement
NOTE:
If replacing the driver's airbag after deployment, refer to
Component Replacement/Inspection After Deployment for a
complete list of other parts that must also be replaced.
...