NOTE:
For a cruise control problem, check the clutch pedal position switch.
For a clutch interlock operation problem, check the clutch interlock switch.
Remove the driver's floor mat before adjusting the clutch pedal.
If there is no clearance between the master cylinder piston and the push rod, the release bearing will be held against the diaphragm spring, which can result in clutch slippage or other clutch problems.
Without cruise control: The adjusting bolt is substituted as clutch pedal position switch. The clutch pedal height adjustment is same procedure as with the clutch pedal position switch.
Disconnect the clutch pedal position switch connector and the clutch interlock switch connector.
Loosen the clutch pedal position switch locknut (A), and back off the clutch pedal position switch (B) until it no longer touches the clutch pedal (C).
Loosen the master cylinder pushrod locknut (D), and turn the pushrod (E). Measure the clutch pedal stroke (F).
(F) |
Clutch Pedal Stroke: |
120пјЌ130 mm (4.72пјЌ5.12 in) |
(G) |
Clutch Pedal Free Play (Reference): |
4.1пјЌ17.4 mm (0.161пјЌ0.685 in) |
(H) |
Clutch Pedal Height (Reference): |
150 mm (5.91 in) |
(I) |
Clutch Pedal Disengagement Height (Minimum to the floor) (Reference): |
75.7 mm (2.98 in) |
Tighten the master cylinder pushrod locknut (A).
With the clutch pedal released, turn in the clutch pedal position switch (B) until it contacts the clutch pedal.
Turn in the clutch pedal position switch an additional 3/4 to 1 turn. Make sure the clutch pedal height did not change.
While holding the clutch pedal position switch, tighten the locknut (C).
Loosen the clutch interlock switch locknut (A).
Fully press the clutch pedal to the floor, then release the clutch pedal 9пјЌ12 mm (0.35пјЌ0.47 in) and hold it there.
Adjust the position of the clutch interlock switch (B) so the engine starts with the clutch pedal in this position.
While holding the clutch interlock switch, tighten the locknut.
Check the clutch operation.
Connect the clutch pedal position switch connector and the clutch interlock switch connector, then check the cruise control and clutch interlock operation.
If the Engine Overheats
The high temperature indicator should be off under most conditions.
If the engine coolant temperature gets higher than normal, the indicator will
blink. If it stays on, you should determine the rea ...
Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
lower left corner of the dashboard.
► The hood will pop up slightly.
3. Push ...
Rear Inner Fender Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the body.
Remove the screws (A) and the clips (B, C), then remove the rear inner fender
(D).
NOTE: T ...