Honda Fit: Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
-
Raise the vehicle on a lift.
-
Disconnect the output shaft (countershaft) speed sensor connector (A).
-
Remove the output shaft (countershaft) speed sensor (B).
-
Install the parts in the reverse order of removal with a new O-ring (C).
See also:
Auxiliary Input Jack
Use the jack in the console compartment to connect standard audio devices.
1. Open the AUX cover.
2. Connect a standard audio device to
the input jack using a 1/8 inch/3.5
mm stereo miniplug.
& ...
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) from ...
Servo Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
Inspect the servo body for scoring and damage.
Check all valves for fre ...
Categories
