Honda Fit manuals

Honda Fit: Countershaft Reassembly (M/T)

Exploded View


Special Tools Required

NOTE: Refer to the Exploded View, as needed, during this procedure.

  1. Clean all parts in solvent, dry them, and apply MTF to all contact surfaces.

  1. Install the 1st gear distance collar (A), with the needle bearing (B), 1st gear (C), and friction damper (D) on the shaft.

  1. Install the 1st gear synchro ring (E) and synchro spring (F) on the shaft.

  1. Align the fingers (A) on the friction damper with the grooves (B) on the 1st/2nd synchro hub (C), then install the 1st/2nd synchro hub onto the shaft.

  1. Install the reverse gear (A). Install the double cone synchro assembly (B) with the synchro spring (C) by aligning the synchro ring fingers (D) with the 1st/2nd synchro hub grooves (E).

  1. Install the 2nd gear distance collar (A) and friction damper (B), then align the fingers (C) on the friction damper and the grooves (D) in the 1st/2nd synchro hub.

  1. Install the needle bearing (A) and 2nd gear (B).

  1. Support the countershaft (A) on steel blocks, then press on 3rd gear (B) using the 40 mm driver handle (C), 35 mm bearing driver attachment (D), and a press (E).

    NOTE: Do not exceed the maximum pressure.

  1. Press on 4th gear (A) using the 40 mm driver handle (B), 30 mm bearing driver attachment (C), and a press (D).

    NOTE: Do not exceed the maximum pressure.

  1. Press on 5th gear (A) using the 40 mm driver handle (B), 30 mm bearing driver attachment (C), and a press (D).

    NOTE: Do not exceed the maximum pressure.

  1. Press on the needle bearing (A) using the 40 mm driver handle (B), 25 mm bearing driver attachment (C), and a press (D).

  1. Press on the ball bearing (A) using the 40 mm driver handle (B), 25 mm bearing driver attachment (C), and a press (D).

  1. Install the 22 mm spring washer (A) and a new 22 mm   locknut (left-hand threads) (B).

  1. Securely clamp the countershaft assembly in a bench vise with wood blocks.

  1. Torque a new locknut to 108 NВ·m (11.0 kgfВ·m, 79.6lbfВ·ft),   then loosen it and torque it again to the same value. Stake the locknut tab into the groove.

See also:

Engine Coolant
Specified coolant: Honda Long Life Antifreeze/Coolant Type 2 This coolant is premixed with 50% antifreeze and 50% water. Do not add any straight antifreeze or water. We recommend you check the en ...

Automatic Transmission
■Creeping The engine may run at a higher idle speed and creeping increases: • Immediately after the engine starts. • When the heating and cooling system is in use. Keep the brake pedal f ...

Refilling Window Washer Fluid
Models without washer level sensor Check the amount of window washer fluid. Look for 1/2 mark on the reservoir. If the level is low, fill the washer reservoir. Models with washer level senso If ...

© 2024 Copyright www.hfitinfo.com